Do not use more than one tube per dog/puppy and do not treat more than once per month. Do not allow your dog/puppy to ingest this product. Do not bathe your dog 48 hours prior to application.

BioSpot Active Care^™ Flea & Tick Spot On^® for Dogs works by application directly to the dog's/puppy's skin, not to the hair. Do not get this product in dog's/puppy's eyes or mouth. Note: Application assumes one tube per dog per application.

Directions for use with applicator:

1. OPEN: Use finger scoop to lift open green door.
2. LOAD: To Load, place tube WHITE SIDE UP under the green tabs.
3. CLOSE: Close the green door and the tube will snap open.
4. APPLY: The dog/puppy should be standing for easy application. To apply, use the front edge of the Smart Shield^® applicator to part hair and get next to dog's/puppy's skin. Press circle on green door once at each of two to three evenly placed spots between the shoulder and the base of the tail. Do not apply an excessive amount of the solution at any one spot that could cause some of the solution to run off the side of the dog/puppy. Do not spread the product by hand over the dog/puppy. Although the dog's/puppy's skin and hair oils will distribute the application over the entire dog/puppy, brushing the dog/puppy 12-24 hours after treatment will help to distribute the material over the skin.
5. DISPOSE: When finished, hold the Smart Shield^® applicator over trash. To dispose of empty tube, open green door and drop empty tube into trash or offer for recycling if available. Close the Smart Shield^® applicator device door and store in original package.
7. RETREAT: Repeat application every 30 days. Do not reapply product for 30 days. Do not treat more than once per month.

Directions for use WITHOUT applicator:

1. OPEN: Bend at perforation and tear off top of tube. Hold tube upright and snap tip back, away from face and body.
2. APPLY: The dog/puppy should be standing for easy application. Apply BioSpot Active Care^™ Flea & Tick Spot On^® for Dogs evenly to two to three spots on the top of the back from the shoulder to the base of the tail. At each spot, part the hair until the skin is visible. Place the tip of the tube on the skin and gently squeeze to expel a portion of the solution on the skin. Do not apply an excessive amount of the solution at any one spot that could cause some of the solution to run off the side of the dog/puppy.
3. DISPOSE: To dispose of empty tube, drop empty tube into trash or offer for recycling if available.
4. RETREAT: Repeat application every 30 days. Do not reapply product for 30 days. Do not treat more than once per month.

BioSpot Active Care^™ Flea & Tick Spot On^® for Dogs is most effective when used as part of a total flea and tick management program. Use other BioSpot Active Care^™ products registered for residential area control of these pests in conjunction with this treatment. Monthly treatments are required for optimal control and prevention of fleas. The successive feeding activity of fleas on dogs may elicit a hypersensitivity skin disorder known as flea allergy dermatitis (FAD). Treatment of dogs with BioSpot Active Care^™ Flea & Tick Spot On^® for Dogs rapidly kills fleas and may reduce the incidence of this condition.

Active Ingredients:
Etofenprox: 50.00%
Piperonyl Butoxide*: 9.10%
N-octyl bicycloheptene dicarboximide (MGK 264^®): 0.91%
Pyriproxyfen (Nylar^®): 0.45%
(S)-Methoprene: 0.23%
Other Ingredients: 39.31%
Total: 100.00%

Keep out of reach of children.

Do not use on cats. Keep cats away from treated dog/puppy for 24 hours. If applied to a cat or ingested by a cat, contact your veterinarian.

Hazards to Humans: Causes moderate eye irritation. Avoid contact with eyes, skin, or clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet.

Hazards to Animals: Do not use on dogs or puppies less than 12 weeks old or weighing less than 5 lbs. Do not use this product on debilitated, aged, medicated, pregnant or nursing animals or on animals known to be sensitive to pesticide products without first consulting a veterinarian. Sensitivity, such as slight transitory redness of the skin at the site of application, may occur after using ANY pesticide product for pets. If signs of sensitivity occur, bathe your pet with mild soap, rinse with large amounts of water, and consult a veterinarian immediately.

Side Effects: Monitor your dog after application. Side effects may include signs of skin irritation such as redness, scratching, or other signs of discomfort. Gastrointestinal signs such as vomiting or diarrhea have also been reported. If these or other side effects occur, consult your veterinarian or 800-234-2269.

Storage: Store in cool, dry (preferably locked) area away from children and animals. Do not store unused tubes separately from their packaging.

Liquid Tube Disposal:
If empty: Do not reuse empty tube. Place in trash or offer for recycling if available.
If partly filled: Call your local solid waste agency for disposal instructions. Never place unused product down any indoor or outdoor drain.

Search website for other available options